Nissan 370Z Tech Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
65 Posts
Discussion Starter #1
I want to put a switch in my ash tray area..but i don't know where to run the wires. I want it to be consealed. how do i get the wires from inside the ash tray to the engine? thx guys
 

·
Registered
Joined
·
16,332 Posts
pull the ashtray out, and there is a screw beneath it. There are two screws behind the seats and two below the shifter cover. Take them all out and you can lift up the entire center console.
 

·
Registered
Joined
·
406 Posts
Here's a photo of the interior [passenger side] with the rug and side panels removed. You might want to route your proposed wire from the ash tray area in this fashion.
 

Attachments

1 - 3 of 3 Posts
Top