[Sultan Of Submission]

I recently replaced my flywheel, clutch and pressure plate on my 2008 nissan 350z and when i was putting everything back i cannot find what goes in this connector. These two connections are located right next to the starter, i could be completely dumb and overlooking it. Any help would be appreciated

 

[dkmura]

Have you tried tracing the wire back to its source? My guess is a 02 sensor connector, but it's hard to tell from that shot.

 

[Sultan Of Submission]

The o2 sensors are all hooked up, i have tried tracing it back and i had no luck

 

[Sultan Of Submission]

Have you tried tracing the wire back to its source? My guess is a 02 sensor connector, but it's hard to tell from that shot.

Idk if this will help any but here is a shot from the back of the trans lookin towards the front. The 2 connectors are right in front of the slave if tht helps any

 

[dkmura]

From that angle, I'd look up on top of the tranny for a plug that needs a mate. Not sure what it is...

Also, do you have access to the FSM to check the wiring schematic?

 

[Sultan Of Submission]

From that angle, I'd look up on top of the tranny for a plug that needs a mate. Not sure what it is...

Also, do you have access to the FSM to check the wiring schematic?

I looked and couldn't find anything on top of the tranny, sadly i dont have fsm

 

[dkmura]

Ask and ye shall receive: Nissan Service Manuals - NICOclub