Nissan 350Z / 370Z Tech Forums banner
1 - 2 of 2 Posts

· Vendor
Joined
·
318 Posts
Discussion Starter · #1 ·
Enhance the sporty style of your 2009-2020 Nissan 370Z and improve its aerodynamics with the recently-released lineup of stylish performance-oriented front and rear spoilers crafted by Carbon Creations. Engineered from the finest quality Carbon Fiber to make your car more aerodynamic at high speeds, they will also impress you with their everlasting durability and aggressive style. They come covered with a clear, scratch, and UV-resistant protective finish that shields the components from getting damaged and scratches.

Carbon Creations - M Spec Style Carbon Fiber Rear Lip Spoiler Add On



Fits: 2009-2012 Nissan 370Z

Notes: Must be used with Factory spoiler.

Carbon Creations - Tornado Style Carbon Fiber Rear Lip Spoiler



Specifications:

Installation Type: Bolt-On
Material: Carbon fiber
Third Brake Light: Without
Quantity: 1 piece

Carbon Creations - EVS Style Carbon Fiber Front Bumper Lip Under Spoiler Air Dam



Specifications:

Material: Carbon fiber
Quantity: 3 pieces

Features:

  • Racing inspired aerodynamics and style
  • Used by professionals in auto racing, drifting and drag racing
  • Made from 100% Grade-A Carbon Fiber
  • Up to 70% lighter than OEM parts while retaining maximum strength and durability
  • Comes with hardware kit and authenticity badge
  • Intended for off-road or show use only

Read more about the new Carbon Creations Products on this page.
 

· Super Moderator
Joined
·
1,952 Posts
The problem with most aftermarket 350Z exterior panels/sections is they are usually built of duraflex or FPG. Both are brittle and vulnerable to damage. Unless you live in a warm weather climate year round, and drive on smooth roads, these body panels simply don't last. Are there any high quality urethane parts available for the Z33 after almost 20 years of development?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top