Jacking the Z up

4346 Views 6 Replies 6 Participants Last post by craigy, Apr 22, 2005

blkZ

Discussion Starter · Mar 21, 2005

I have two ramps that I can back the Z onto to work underneath on the exhausts and stuff...but you can't drive up into the ramps to lift your front up if you wanted to work on headers. any suggestions how to get underneath the front of the car. plus,,do you need to use a power jack to lift up one end then place some stands there? very lost

Save

1 - 1 of 7 Posts

smoothz

· #5 · Mar 21, 2005

Or you could buy ramps made for low cars and lower front bumpers...like I have.

I drove my Z on to the ramps, then jacked up the rear, put the stands underneath, swung around to the front, jacked that up and put the other 2 stands there. Voila!

Save

1 - 1 of 7 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Home
Forums
Technical Area
Maintenance & Repairs
Jacking the Z up

Top Contributors this Month