Nissan 350Z / 370Z Tech Forums banner

Jacking the Z up

4346 Views 6 Replies 6 Participants Last post by  craigy
I have two ramps that I can back the Z onto to work underneath on the exhausts and stuff...but you can't drive up into the ramps to lift your front up if you wanted to work on headers. any suggestions how to get underneath the front of the car. plus,,do you need to use a power jack to lift up one end then place some stands there? very lost
1 - 1 of 7 Posts

I do the same thing to jack mine up. Now when I need to jack up the entire car (see my sig) I just alternate front to back, jack it up enough in front to get the stands in place then go to the back and do the same thing. Little by little until it's to the height I need.
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.