Nissan 370Z Tech Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,154 Posts
Discussion Starter #1
I am not too sure if this is what you are after... but my torque curves looks a bit funny, not that flat between 4000 to 5600rpm... it just suddenly jumps up.... don't know if I can be able to make the torque curve flat through further tuning on the VTC/cam angles..... but anyway... here is the curve that I requested today (they put it up and run it for me today)...

cheers,

richie

ps. will do another dyno sometime soon on another machine.... to see how it goes...
 

·
Registered
Joined
·
1,154 Posts
Discussion Starter #2
Just found out another dyno sheet that's very similar to mine....... it is shown in Hyper Rev magazine on Amuse's latest 350Z with 349HP... and it has its compression ratio raised up to 12:1 using Nismo Spec 2 heads and Nismo Spec 2 cams and also the nismo VTC units... the torque curve is nearly exactly the same.... I think that might be how the S-Tune engine acts on the torque with the new VTC settings?!

Just a thought, but not too sure why...

cheers,

richie
 
1 - 3 of 3 Posts
Top