LED Taillight Installation

From Nissan 350Z & 370Z Wiki

This install is about as easy as you can get. But I would still take my time with it.

Pop the blacks caps covering the bolts off using a flathead screw driver. With a 10mm wrench unscrew the three bolts on each light.

When removing the old light housings, pull from the skinny end first and slowly work your way down towards the wider end (trust me on this, you don't want to start from the wider end).

There's two plugs you have to disconnect (one for each bulb). Pinch the little arrows and ease the plugs out. You only have to use the the bigger plug for the new LEDs (smaller one is not needed, make sure you tuck it away so it won't obstruct the back of the housing)

The bigger plug goes into the only available outlet on the back of the new LED brake light housing.

Once again install the LED lights skinny end first and work you way down until you here them pop into place. Screw the three bolts back on and pop on the caps and BAM you're done.

Pictures of the lit LEDs are of the parking brake. Brakes are way too bright to get decent pictures of them.