From Nissan 350Z & 370Z Wiki
This article is part of our special
collection:
I was asked to do a write up on how I attached my front plate. I
used a DIY by Roark. These pics are from his install.
Parts
- One aluminum L-stock 1-1/2" x 1-1/2" x 1/16" thick, and cut it to 12" long.
- One 5/8" I.D. aluminum square stock cut to 2-3/4" long.
- One metric bolt, 16MM x 90mm long with washer NOTE: The tow hook bolt size has changed over the years. Please verify your bolt size before purchasing
- Two metric screws, with lock nuts and washers. 5mm x 18mm long.
Procedure
Drill an 11/16" hole in the center of the L-stock and run the bolt through the washer, the L-stock and the square stock, threading it into the tow hook hole in the aluminum bumper.
The bottom of the L-stock rests on the top horizontal grill slat, and the square stock keeps the entire assembly rigid.
Notice the smaller holes, drilled at 10-3/16" apart for the stock license plate bracket to mount.
Finished
I painted mine black after I test fit this so the aluminum doesn't show as much.
