Beltronics Vector Installation
From Nissan 350Z & 370Z Wiki
This Is To Hide The Wires For Any Beltronics Vector Series Or Any Other Device Where The Wires Need To Go Around The Back And Connect To The Bottom Power Socket
Contents |
Materials and Tools
- Philips screwdriver With Magnetic Holder
- Velcro
Estimated Time
1 Person....0.50min - 1.30hr
2 People... 0.30min - 1.00hr
Stage 1
First Start By Going To Toykilla's page(Thank You Toykilla) ... http://www.350z-tech.com/zwiki/Tutorial:Head_Unit_Installation To Remove Your Center Console, Begin With "Removing The Console" Follow The First Step, Each picture is counted as ONE step, and continue to step 12 becuase you don't need to remove the stereo.
Stage 2
After Completing Stage 1, unclip the red area, and run the wire through the back
This Is Where The A/C Was At......
Put Your Hand Inside(Red Arrow) And Move Your Hand Upwards And Grab The Wire With Your Other Hand From The Top
Look For A Hole Behind The Stereo(Red Arrows) This Is Where You Grab The Wire From The Top
- Pull the Wire Through The Hole In The Navigation Console
Finished
- Restore Everything, This Will Be Really Easy,It Should Take 2 Minutes Or Less
- Just Velcro The Device And You're Done
